Re: (PM) IP Blocks not being assigned to dial-ins
Butch Kemper (kemper@tstar.net)
Thu, 27 May 1999 17:25:12 -0500
At 01:53 PM 5/27/99 , you wrote:
>
>I just recently added another PM3 into one of our POP's that already had
>4 portmasters installed. However now anyone who dials into that
>portmaster and is normally assigned a netblock via Radius, the
>portmaster is not adding the netblock into it's OSPF routes. If they
>call into another pm in the same group, the netblock is assigned and
>shows up as a route, but the new PM only gives them the correct static
>IP for the gateway but then nothing beyond a /32 shows up in the local
>routing table. The PM does communicate with the rest of the machines via
>OSPF, but won't insert any local routes beyond a /32 into the route
>table.
>Any ideas of what to check that would cause this behaviour? I'm at a
>loss right now. The new PM is going in at the end of the group.
>Thanks in advance.
Make sure that "set user-netmask on" has been set on the new PM.
Butch
TSTAR Internet, Inc | Making the Network Work
Marble Falls, TX | Serving Blanco, Burnet, and
830-693-6967 | Llano Counties
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>