At 15:58 -0700 5/26/99, Steve Coleman wrote:
>Having problems bringing up a new CT1 on a PM3. 3.8.2.c2
>
>pm3-1> show line1
>---------------------- line1 - T1 Inband DS0 ---------------
>
> Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
>
> Signaling: Trunk E&M wink start
>
> Receive Level: +2dB to -7.5dB
>
> Alarms Violations
> ----------------------------- -----------------------------
> Blue 6 Bipolar 133720220
> *Yellow 130 CRC Errors 22019
> Receive Carrier Loss 8 Multiframe Sync 877003
> Loss of Sync 34
>
>Don't pay too much attention to the # of violations and alarms. These were
>caused by unplugging and plugging the T1 many times. None of the Alarms or
>violations are increasing right now. The only thing out of place is the *
>on the "Yellow".
>
>a "show ses" shows the lines as "idle" yet they can't receive a call, and
>the telco says their switch can't see our PM. The light on the WAN ports on
>the PM3 are green, no red.
>
>Any ideas? Livingston couldn't figure it out and had to send it to their
>WAN group. I have the telco here right now, and they are at a loss. Both
>Livingston and the Telco are pointing fingers, and of course I'm caught in
>the middle.
>
>Thanks,
>
>Steve Coleman
>Computer Solutions
>
>-
>To unsubscribe, email 'majordomo@livingston.com' with
>'unsubscribe portmaster-users' in the body of the message.
>Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>
-- Doug
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>