pm3-1> show line1
---------------------- line1 - T1 Inband DS0 ---------------
Status: UP Framing: ESF Encoding: B8ZS PCM: u-law
Signaling: Trunk E&M wink start
Receive Level: +2dB to -7.5dB
Alarms Violations
----------------------------- -----------------------------
Blue 6 Bipolar 133720220
*Yellow 130 CRC Errors 22019
Receive Carrier Loss 8 Multiframe Sync 877003
Loss of Sync 34
Don't pay too much attention to the # of violations and alarms. These were
caused by unplugging and plugging the T1 many times. None of the Alarms or
violations are increasing right now. The only thing out of place is the *
on the "Yellow".
a "show ses" shows the lines as "idle" yet they can't receive a call, and
the telco says their switch can't see our PM. The light on the WAN ports on
the PM3 are green, no red.
Any ideas? Livingston couldn't figure it out and had to send it to their
WAN group. I have the telco here right now, and they are at a loss. Both
Livingston and the Telco are pointing fingers, and of course I'm caught in
the middle.
Thanks,
Steve Coleman
Computer Solutions
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>