Do you do know the limit only apples to pmconsole while the dial
is in
progress and it exits once the location is dialed so you can
dial more then 10
locations using pmcommand you just can not be dialing more the
10 at the same
time. Once the location is connected the pmcommand session
exits but the dial
out session stays active.
We have 5000 customers (hospitals) to where we dialout from our office.
And simeltaniously there are requirements (from our experiance) to
dialout to more than 10 customers... We have a tool which will use
pmcommand to dialout. pmcommand create the location table to dialout.
This tool is available across LAN so anybody can dialout to the
customers whenever it is required. Now how do i establish the connection
if iam
dialing out as a 11th user ?
That is the reason i was enquiring about the control sessions...
Also can you not use locations to dial out?
I did not understand this.... Pls explain...
TIA
Regards
Shibu
--
Thomas C Kinnen - <tkinnen@ra.lucent.com> <tkinnen@sobhrach.com>
[RADIUS Test Engineer] - LUCENT Technologies RABU
"All of the opinions stated above are my own and not my
employer's,
unless they were given to me by my employer"
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive:
<URL:http://www.livingston.com/Tech/archive/>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>