Command> set debug isdn on
Enabling ISDN debugging
Command> TELNET SEND: WILL - 0x3
TELNET SEND: WILL - 0x1
TELNET RECV: DO - 0x3
TELNET RECV: DO - 0x1
S10: Sending Call Request - 8882449 (VOICE)
S10: Received Disconnect Clear Normal Clearing (B11 ID:800b)
S10: Sending Call Request - 8882449 (VOICE)
S10: Received Disconnect Clear Normal Clearing (B11 ID:800b)
S10: Sending Call Request - 8882449 (VOICE)
S10: Received Disconnect Clear Normal Clearing (B11 ID:800b)
remote_shutdown: Host connection terminated on fd: 72
set debug ISDN off
Disabling ISDN debugging
This shows the results from at&n0dtxxx. at&n1dtxxx, and at&n56dtxxx. The
dial commands are issued from a telnet session at port 6005. S10 is set up
for this port as follows:
Status: IDLE
Input: 0 Abort Errors: 0
Output: 0 CRC Errors: 0
Pending: 0 Overrun Errors: 0
TX Errors: 0 Frame Errors: 0
Modem Status: DCD- CTS+ TELCO+ Disconnect: Normal Clearing
Active Configuration Default Configuration (* = Host
-------------------- --------------------- Can
Override)
Port Type: TwoWay/Netwrk TwoWay/Netwrk (Dial In & Out)
(Security)
Login Service: Rlogin Rlogin
Device Service: Telnet@6005 Telnet@6005
Line Speed: 64000 64000
Hosts: default
Host Device: Network
Terminal Type:
Login Prompt: $hostname login:
Idle Timeout: 1 minutes
Dial Group: 0
Directory No:
Session termination history:
7 min - Host Request
10 min - Idle Timeout
Command>
Thanks again ...jgm
-----Original Message-----
From: Thomas C Kinnen [SMTP:tkinnen@livingston.com]
Sent: Sunday, May 16, 1999 3:19 PM
To: Joe Moore; Mail List - Portmaster Users
Subject: Re: (PM) dial-out IP modem pooling
Have you verified you have dial out support on the PRI? Many times unless
you ask for dial on on the PRI the phone company will only enable dial in
if
you tell them it's for a NAS.
Also what does an ISDN debug show when you try to dial?
-- Thomas C Kinnen - <tkinnen@ra.lucent.com> <tkinnen@sobhrach.com> [RADIUS Test Engineer] - LUCENT Technologies RABU "All of the opinions stated above are my own and not my employer's, unless they were given to me by my employer"- To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>