Please keep mail list replies on the list. Others may need this info also.
> What is the "at" command to go analog? I can't find it in the docs. I can
> only "set analog on" when referring to a "location".
http://www.livingston.com/tech/docs/command/async.html#37039
> I've tried at&n0, at&n10, at the suggestion of a Lucent tech, and at&n56
> (which I found in the archive of this list) and then an atdt with the
&N10 or &N1? Also &N56 makes an ISDN call.
Try:
AT&N0dt <phone number>
AT&N1dt <phone number>
> number I'm trying to call. If I'm PMvisioned into the PM3, the monitor
> shows a session light go blue shortly after telnetting in and issuing any
> command. After an "atdt" command, one of the modem lights flashes black
> once and yellow three or four times, then goes back to normal and thats all
> that happens. "DialOut IP" installed OK, it finds the PM3, says it detects
Have you verified you have dial out support on the PRI? Many times unless
you ask for dial on on the PRI the phone company will only enable dial in if
you tell them it's for a NAS.
Also what does an ISDN debug show when you try to dial?
-- Thomas C Kinnen - <tkinnen@ra.lucent.com> <tkinnen@sobhrach.com> [RADIUS Test Engineer] - LUCENT Technologies RABU "All of the opinions stated above are my own and not my employer's, unless they were given to me by my employer" - To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>