RE: (PM) Portmaster 2e and RADIUS Port number

James Courtier-Dutton (dutton@livingston-ent.co.uk)
Thu, 13 May 1999 16:47:02 +0100

Hello
The PM2 cannot at present be set to port 1812 etc.
As a work around (until ComOS 3.9 comes out) you could set up a radius
server just for the PM2, and just make it proxy everything to your normal
radius servers.
Then when ComOS 3.9 comes out, you can dump this temporary radius server.
Cheers
James

> -----Original Message-----
> From: owner-portmaster-users@livingston.com
> [mailto:owner-portmaster-users@livingston.com]On Behalf Of Jose Carlos
> da Silva
> Sent: Thursday, May 13, 1999 12:38
> To: portmaster-users@livingston.com
> Subject: (PM) Portmaster 2e and RADIUS Port number
>
>
> Dear Portmaster users,
>
> I am setting up a Portmaster 2e in my network where I already have a
> RADIUS server running on port 1812/1813 which are the current ports
> used by RADIUS accordingly to the LATEST RFCs. I have already several
> NASes using this RADIUS server on these ports, including a Livingston
> Portmaster 3.
>
> After playing around with my Portmaster 2e, I couldn't find a way to
> change the RADIUS port it uses to 1812/1813. I've even upgraded the
> ComOS to version 3.7.2c4 (the latest available on Livingston web site
> tomorrow) and even after that, I am still unable to change the ports
> used by Portmaster.
>
> Is there a solution for this problem? If I have to change my RADIUS
> to use the old RFC ports, I would need to change the setup of all my
> other NASes which should'nt be good for me.
>
> Regards,
>
> Jose Carlos da Silva
> Network Administrator
> ALLNET Internet
> -
> To unsubscribe, email 'majordomo@livingston.com' with
> 'unsubscribe portmaster-users' in the body of the message.
> Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>
>
>

-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>