Is it possible to force Portmaster to use a certain MTU value for a
dial-in port? I've used the commando "set all mtu 576", and altough
this configuration was accepted, any dial-in user is able to use
values above this limit for MTU speed. Here's a sample of the output
of a "show s1" command:
----------------------- Current Status - Port S1 ---------------------------
Status: ESTABLISHED
Input: 436024 Parity Errors: 0
Output: 1896688 Framing Errors: 0
Pending: 1086 Overrun Errors: 0
Modem Status: DCD+ CTS-
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Login/Netwrk (Dial In) (Security)
Baud Rates: 115200 115200,9600,9600
Flow Control: RTS/CTS RTS/CTS
Modem Control: on on
Modem Config: Configured boca
Remote Host: dial-131.allnet.com.br
Netmask: 255.255.255.255 0.0.0.0
Interface: ptp1 (PPP,Quiet,VJ-Comp)
Mtu: 1500 576
Async Map: L:00000000 R:000a0000 00000000
Dial Group: 0
Regards,
Jose Carlos da Silva
Network Administrator
ALLNET Internet
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>