----------
From: Thomas Kinnen[SMTP:tkinnen@livingston.com]
Reply To: Thomas Kinnen
Sent: Thursday, May 06, 1999 4:14 PM
To: 'portmaster-users@livingston.com'
Subject: Re: (PM) PM4 PRI : problem
"Nair, Shibu (MED, Wipro Systems, Inc)" wrote:
> All ports (S0-Sn) is already configured for outbound
calls (Dial
> in and out)...
> I do not know how to see PRI configuration for
outbound
> connnection config...
> How do i see this...?
You would have to ask the telco. Did you say it worked dialing
out on a PM3?
If so then the PRI is ok. What happens if you run a debug when
trying to dial
out?
--
Thomas C Kinnen - <tkinnen@ra.lucent.com> <tkinnen@sobhrach.com>
[RADIUS Test Engineer] - LUCENT Technologies RABU
"All of the opinions stated above are my own and not my
employer's,
unless they were given to me by my employer"
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive:
<URL:http://www.livingston.com/Tech/archive/>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>