Re: (PM) Limiting modem access to V34+
Thomas C Kinnen (tkinnen@livingston.com)
Tue, 04 May 1999 14:45:16 -0700
Tim Tsai wrote:
>
> > You can use the Group and NAS-IP-Address attributes as check items to do
> > this. Say the PM3 is at .1 and the PM2 at .2
> >
> > DEFAULT Auth-Type=System, NAS-IP-Address=10.1.1.1, Group="fast"
> >
> > DEFAULT Auth-Type=System, NAS-IP-Address=10.1.1.2
>
> This doesn't help those of us with all PM3's. I hope that when the
> V.34 only command is available, it is configurable on a per-modem basis
> through RADIUS. I think Lucent is about the only NAS vendor left that
> still can not do this.
If you have all PM3's just add a NAS-Port-Type and Connect-Rate check item.
Also unless you're running call-check and using calling-station ID the modem
protocol is already setup before RADIUS
--
Thomas C Kinnen - <tkinnen@livingston.com> <tkinnen@sobhrach.com>
[RADIUS Test Engineer] - LUCENT Technologies RABU
"All of the opinions stated above are my own and not my employer's,
unless they were given to me by my employer"
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>