Re: (PM) Total control session on pm3/pm4...?

D. Scott Gardner (sgardner@livingston.com)
Mon, 03 May 1999 17:28:17 -0700

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Josh Ebel: "Re: (PM) Modem Code"
Previous message: Craig Heading: "Re: (PM) Modem Code"
Maybe in reply to: MED, Wipro Systems, Inc: "(PM) Total control session on pm3/pm4...?"

>>set max pmconsole x (where x is 1-10).
>>
>>i'm not sure if pmvision uses this same value, i wouldn't think so as
>>they (pmconsole vs pmvision) use different ports to connect.

PMVision and PMconsole both use the same port (tcp 1643). The command is
still the same syntax for compatibility purposes.

D. Scott Gardner sgardner@livingston.com
925.737.2217

Lucent Technologies, Remote Access Business Unit
4464 Willow Road
Pleasanton, CA 94588-8519
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>

Next message: Josh Ebel: "Re: (PM) Modem Code"
Previous message: Craig Heading: "Re: (PM) Modem Code"
Maybe in reply to: MED, Wipro Systems, Inc: "(PM) Total control session on pm3/pm4...?"