Re: (PM) CLI information

Matthew Walker (mwalker@lidcam.com.au)
Wed, 10 Feb 1999 13:55:50 +1100

Richard Morrell <portmaster@ednet.co.uk> writes:
>Sorry if this has been discussed before, but I did check the archive and
>couldn't find anything relevant.
>
>When doing PPP traces, users sometimes don't even get to authentication
>stage which makes it difficult to tell which port they are coming in on
>(on a busy NAS). Is there anyway of getting Caller Line Identification
>(CLI) information from the portmangler rather than through RADIUS
>accounting? Does it show up in any of the debug modes?

G'Day Richard,

the best one I have found is:

set debug mdp-internal

This displays the port and the CLI information when the call is answered
and not too much else.

Regards

Matthew Walker

Matthew Walker <mailto:mwalker@lidcam.com.au> Lidcam Technology
Ph: +61 3 9865 9077 Level 5 499 St Kilda Rd
Fax: +61 3 9866 1245 Melbourne VIC 3004
<http://www.lidcam.com.au/users/matthew/> AUSTRALIA
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>