Last Friday I converted my dialin lines from channelized T1 to PRI. I
unplugged the cable from the channelize T1 wall jack and reconfigured
the PM-3 using the following commands.
set isdn-switch ni-2
set line0 isdn
set line1 isdn
save all
I plugged the cable into the PRI wall jack and the portmaster seemed
happy. However the GTE guy in the CO said that the circuit was in
loopback. I did a "show line0" and "show line1" and did not see any
reference to loopback. I then tried
set line0 loopback off
set line1 loopback off
with no success. I ended up rebooting the PM-3 which brought
everything up properly and the GTE guy said that the circuit was no
longer in loopback.
I then tried
set line0 loopback on
set line0 loopback off
and he said that he didn't see any change in the circuit.
Rebooting the PM-3 clearly corrected the problem but I have two
questions.
How can I turn off loopback without rebooting the PM-3?
What does the "set lineX loopback" command really do?
_____ ___ ___ ___
(_ _)( )( \/ ) Tim Moloney Think of something
) ( ) ( ) ( moloney@netsrq.com witty and imagine it
(___) (___)(__)\/(__) Sarasota, Florida was written here.
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>