> What doesn't work is if the OR-U dialed the first channel to the PM2
> then the High-Water gets hit comming back from the PM2 and the PM2 dials
> the OR-U to bring up another channel. From looking a the debug output
> it seems that the PM2 is dialing the number for the first channel and
> getting a busy and doesn't know enought to dial the second number. For
> the location I have the both numbers listed separated by an &. I
> suppose I could get Bell to make it a hunt but I don't think that is
> right answer.
If the BRI does not roll over and you dial the first number then you will
get a busy. You can try reversing the numbers on the PM side of the
connection. This would have the effect that if the OR dials and then the
PM diales you will get the second channel on the OR. Not sure if this
will get what you want though as I've not tried it but you may want to
give it a shot.
Tom
----
Thomas C Kinnen - <tom@lcp.livingston.com>
[Test Engineer] - LUCENT Technologies - Remote Access Business Unit
<URL:http://www.livingston.com/> * <URL:http://www.lucent.com/dns/>
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>