> >> >modem to it. The dip switch is set to autoanswer mode, and AA is lit. So
> is
> >> >TR and CS. When a call comes in, the modem picks up and hangs up really
> >> >fast (you can tell from the audible clicks). It does so so fast that
> phone
>
>
> >
> >----------------------- Current Status - Port S1
> > Status: USERNAME
> > Input: 419 Parity Errors: 0
> > Output: 256 Framing Errors: 9
> > Pending: 0 Overrun Errors: 0
> > Modem Status: DCD- CTS+
> >
> > Active Configuration Default Configuration
> > -------------------- ---------------------
> > Port Type: Netwrk Netwrk (Dial In)
> > Baud Rates: 38400 38400,115200,115200
> > Flow Control: RTS/CTS RTS/CTS
> > Modem Control: off on
> > Modem Config: Configured bleh
> >
> > Interface: Unassigned (SLIP,Listen)
> > Mtu: 0 0
> > Dial Group: 0
>
>
>
> Couple of things:
>
> Your Modem Control os set to off. If you have modems on all the ports do a
> 'set all modem on'.
>
> Also you have speed 1, 2 and 3 set to different speeds. Set them all to the
> same speed 'set all speed 1 38400', 'set all speed 2 38400', 'set all speed
> 3 38400'.
Wouldn't 57600 or 115200 be a better port rate? You may get overruns if
you set it to 38400...
> Was someone trying to log in when you took this capture? Currently the port
> is in username which means someone is loggin in or the carrier detect thinks
> someone is connected.
but DCD is still - .... you might want to check the cabling to make sure
that the DTR pins are connected... without the DTR modem will answer but
the PMx will not notice it... I had that happen on an OR-HS...
> >I'm not sure how to determine the firmwave config. Where is this
> >documented or what is the command?
>
>
> It's ati4, ati5, or ati6 (I can not remember at this moment).
ati-atx
meaning ati, ati1, ati2, ati3, ... , highest I've seen is ati7
Most new firmwares use ati3 as the common location to show firmware
revision.... 8) but things in this industry are never consistent soooooo,
go through them all to see.
> Thomas C Kinnen - <tom@lcp.livingston.com>
> [Test Engineer - Radius ABM] - LUCENT Technologies RABU
Thomas since I hassle Chad/Josh about being betas.... what does it mean
that you're a 'Test Engineer?' ... something like we hook you up to test
things in RADIUS ABM? 8)
-- Aloha from Paradise,Sherwood
- To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>