Re: (PM) PM3 - second PRI does not answer analogue calls

Thomas C Kinnen (tom@lcp.livingston.com)
Fri, 3 Jul 1998 10:48:35 -0700

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Jake Messinger: "Re: (PM) Which router to use for BGP-4?"
Previous message: Tom: "Re: (PM) Which router to use for BGP-4?"
Maybe in reply to: Steve Mead: "(PM) PM3 - second PRI does not answer analogue calls"

>Have a PM3 (ComOS 3.7.2) with 2 PRI's. It answers analogue calls with "no
>tone" on the second PRI, incoming calls on the first are fine.
>ISDN service is fine on both PRI's. debug isdn, isdn-d, isdn-m and
>mdp-status all show the same output for incoming calls on bith PRI's.
>Short of interchanging the PRI's (and its 100 miles away) I'mn stumped.

Has it ever worked or is this a new line?
Check with the telco to make sure they put VOICE service on the line also.
You can have an ISDN only PRI. Also if you plan on outbound calls you may
what to verify you have outbound service also if you find you have no voice
service.

Tom

----
Thomas C Kinnen - <tom@lcp.livingston.com>
[Test Engineer - Radius ABM] - LUCENT Technologies RABU
<URL:http://www.livingston.com/> * <URL:http://www.lucent.com/dns/>

-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>

Next message: Jake Messinger: "Re: (PM) Which router to use for BGP-4?"
Previous message: Tom: "Re: (PM) Which router to use for BGP-4?"
Maybe in reply to: Steve Mead: "(PM) PM3 - second PRI does not answer analogue calls"