> Has anyone gotten Shotgun Technology to work with pm3 ComOs 3.8b15?
> Is there any special set-up needed to enable it, or is it all client side?
> TIA
> Tommy Dorsey
We had to contact Diamond Tech Support to get the correct init string to
disable the v.90 and use k56flex by default. After that it worked fine...
for the most part. I still had the occasional 2nd line connect failure
that made the second line unusable until I rebooted. My normal connects
were 42k + 44k for a total of 86k. My transfers of compressed files got up
to around 7-7.5k. Its not ISDN by a long shot but it works ok for the
occasional big file transfer from home.
Below is a copy of the email I recieved from Diamond:
> Use Regedit, open HKEY_LOCAL_MACHINE, open SOFTWARE, open Diamond
> Multimedia, open Shotgun, click on the Line1 folder, in the right side
> of Regedit, double click on the Init line to edit, add +MS=56,0 to the
> end. Do the same for Line2, close Regedit, you're done. The modem will
> now dial-out in Flex mode only. To return the modem to V90/Flex just do
> the same process again, but remove the +MS=56,0.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Don Knott, Treasure Coast Internet - http://www.treco.net
759 S Federal Highway - Suite 316 - Stuart, FL 34994-2923
Stuart: 286-6998 Ft. Pierce: 879-6177 Fax: 286-7089
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>