Re: (PM) BACP, b13 and Ascend
Kevin A. Smith (kevin@ascend.com)
Thu, 18 Jun 1998 16:24:21 -0700
At 03:50 PM 6/18/98 -0700, Kevin A. Smith wrote:
>At 03:10 PM 6/18/98 -0700, Jon Rust wrote:
>>PM3's PRI 3.8b13
>>
>>It appears that either Ascend or Lucent has bad BACP code. In particular,
>>P75s (6.0.2) can connect with one channel, then increase to 2. At some
>>point, due to traffic dropping off, or an incoming phone call, the second
>>channel drops. After that point, the Ascend can no longer connect a
>>second channel. The whole connection has to be dropped and re-iniated.
>
>Is the call attempt being re-made? Is it failing on connection?
>
>I'll set my P85 to BACP and call into the MAX to make sure it's not
>a problem there - at least to isolate it a bit.
Oh well! Best laid plans....they still negotiate MP+ - just because they
can :(
Any insight yet on where it's failing? Protocol traces?
Kevin Smith Ascend Communications...
Customer Satisfaction ...where Network Solutions never end.
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>