I have tried both with voice on and voice off, chap on and chap off.
Later, after much frustration and failure, I tried the same thing with my
PM2e30 and it dialed out right away - just can't seem to force the PM3 to
dial over PRI lines.
On Sun, 14 Jun 1998, Thomas C Kinnen wrote:
>
>
> >I tried changing dial group to 1, still no success
> >>
> >> Could some kind soul please explain to me the step-by-step to make the
> PM3
> >> dial to some phone number or some ISDN number? Or perhaps see my error
> >> above?
>
>
> Now, have you done an attach and manually dialed from the port to this
> number or an office number? Have you tried an AT&N55 to set it to voice
> mode and then call out? If your PRI has only voice service it will only
> work if the at &N55 is set. You can also to a 'set <location> voice on' to
> test it also.
>
> Tom
>
>
>
> -
> To unsubscribe, email 'majordomo@livingston.com' with
> 'unsubscribe portmaster-users' in the body of the message.
> Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>
>
Jeff Halper
Internet Hotline
408/881-1000 fax 408-293-3456
http://www.ihot.com
mailto:jeff@ihot.com
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>