I've also put the TSU into local loopback, but I do not recieve any
"LCP: Apparent Loop" messages while debug is set to 0x51. The clocking is
set for network, the RS-232/v.35 switch is set to v.35, etc.
What I do see over and over (while not in loop-back) are
LCP_CONFIGURE_REQUEST (see below). So, I try swapping the v.35 cable and
using another Adtran TSU and it does the same thing, including the PLL
alarms.
I even tried the Adtran we are currently using on our cisco with the IRX
v.35 cable, and no go. PLL alarm, and abort errors on the wan port on the
IRX.
This same T1 syncs up to our cisco. Something tells me I've either done
something dumb in an early-morning stupor, or something's broken. Any
ideas what could be wrong?
Some of my debug 0x51 output:
Sending LCP_CONFIGURE_REQUEST to port S1 of 10 bytes containing:
01 05 00 0a 05 06 06 dc e6 4b
Sending LCP_CONFIGURE_REQUEST to port S1 of 10 bytes containing:
01 06 00 0a 05 06 06 dc e6 4b
Sending LCP_CONFIGURE_REQUEST to port S1 of 10 bytes containing:
01 07 00 0a 05 06 06 dc e6 4b
Sending LCP_CONFIGURE_REQUEST to port S1 of 10 bytes containing:
01 08 00 0a 05 06 06 dc e6 4b
Sending LCP_CONFIGURE_REQUEST to port S1 of 10 bytes containing:
01 09 00 0a 05 06 06 dc e6 4b
Sending LCP_CONFIGURE_REQUEST to port S1 of 10 bytes containing:
01 10 00 0a 05 06 06 dc e6 4b
Sending LCP_CONFIGURE_REQUEST to port S1 of 10 bytes containing:
01 11 00 0a 05 06 06 dc e6 4b
[...]
The IRX is setup as follows:
----------------- Current Status - Port S1 ----------------------
Status: CONNECTING
Input: 135387 Abort Errors: 24581
Output: 7798 CRC Errors: 0
Pending: 0 Overrun Errors: 0
TX Errors: 0 Frame Errors: 12
Modem Status: DCD- CTS+
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Hardwired)
Line Speed: Ext 1536K Ext Clock
Modem Control: off off
Remote Host: aaa.bbb.ccc.xx aaa.bbb.ccc.xx
Local Address: aaa.bbb.ccc.xy aaa.bbb.ccc.xy
Netmask: 255.255.255.252 255.255.255.252
Interface: Unassigned (PPP,Routing)
Mtu: 1500 1500
Dial Group: 0
System Name: router
IP Gateway: aaa.bbb.ccc.xx
Gateway Metric: 1
Default Routing: Broadcast, Listen (On)
OSPF Priority: 1
OSPF Router ID: 208.143.228.11
Name Service: DNS
Name Server: fiber.bitstorm.net
Domain: bitstorm.net
Telnet Access Port: 23
Loghost: noc.bitstorm.net
Maximum PMconsole: 1
Assigned Address: 0.0.0.0
RADIUS Server: 0.0.0.0
Alternate Server: 0.0.0.0
Accounting Server: 0.0.0.0
Alt. Acct. Server: 0.0.0.0
PPP Authentication: PAP: on CHAP: on
Disabled Modules: BGP
[I also have a ticket already open with Livingston but thought I'd ask
the list]
Thanks,
-jason
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>