Don
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D post from Kyle
Here it is, hot off the presses. After working with Livingston and
Nortel, we have come up with the requirements to make it work.
Of course I have to warn you, your mileage may vary.
How to do 56k in a DMS-10 on CT1 E&M Wink Start
Trunk to Line padding is hard set to 2db in a DMS-10.
Trunk to Trunk padding should be set to 4db.
Line to Trunk padding should be set to 0db.
DNIS set to 1 digit. 0 digits does not seem to work properly.
The translation is specifically DIOD in the switch.
Kyle Platts
Network Engineer
!NTERPRISE Networking Services
11/11/97
*********** REPLY PARTITION ***********
On 2/4/98, at 9:33 AM, Rick Kunze wrote:
>Hi,
>
>I just (FINALLY) got my CT1 installed with one line on it for testing.
>I've got a +2 to -7.5 level, ami encoding and d4 framing. The telco has a
>DMS10 switch.
>
>I've got a couple of users testing this, but all I'm seeing are connect
>speeds of 26 through 36. The highest is 36K.
>
>Anyone know of any solutions?
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Don Lashier dl@newportnet.com
Newport Internet http://www.newportnet.com/
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.