Livingston recommends using the T1 WAN card, however, if you're using a T1
from a different switch than the line0/line1.
On Tue, Jan 27, 1998 at 03:11:48PM -0800, Roy wrote:
> Yes... The PM-3 derives clocking from line0 only....
>
>
> Jeff Haas wrote:
> >
> > Megazone was heard to say:
> > > 1. If you have only one line, use line0 NOT line1. We clock from line0.
> >
> > Just to verify, if you have two T1 lines, they are clocked independantly
> > from each of the T1s?
> >
> > I could see Bad Things happening if this isn't the case.
> >
> > > - -MZ
> >
> > --
> > Jeffrey Haas -+- jmh@msen.com -+- http://www.msen.com/~jmh
> > /\/\sen, Inc. "Michigan's Best Run Internet Service Provider."
> -
> To unsubscribe, email 'majordomo@livingston.com' with
> 'unsubscribe portmaster-users' in the body of the message.
-- - Steve - Systems Manager - Community Internet Access, Inc. - Gallup and Grants, New Mexico - To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message.