Re: (PM) New PM3 No 56K but ISDN works (fwd)
Ingrid Kast Fuller (ingrid@cityscope.net)
Sat, 17 Jan 1998 18:12:10 -0600
MegaZone wrote:
>
> Once upon a time Ingrid Kast Fuller shaped the electrons to say...
> >Well if it didn't have modem cards, I wouldn't be sending you this note
> >via ISDN would I?
>
> That makes NO sense whatsoever... It doesn't matter if it has modem
> cards or not if ISDN is being used.
Well I keep assuming that you have to have a modem to see a port in
use.
I'm not used to ISDN yet, it's very confusing to see an ISDN call on
what
you think is a MODEM!
> And believe me, we HAVE had people install a PM-3 and not order and modem
> cards and then call in asking why modems can't connect.
I understand....I have the same people calling me on hitting the "any"
key! :)
> >Modem callers can't even be seen with debug running. They aren't
> >getting
>
> The odems are showing 'ready' - right?
> Dial the number with a phone - do you get any messages, busy, tones, etc?
Yes....
I have SW Bell on the phone and they say it's set for voice and data.
When I dial the phone number I get a sharp tone, a pause and then one
continuous
tone. But not a dialtone like you get with an analog phone.
Yesterday, you could dial in with a modem, but couldn't stay connected
for more
than a minute or two. This was using the first PM3. We switched PRI's
and modems
and came to conclusion it was bus problem. Todd (TEK Interactive) was
thinking it
might be a padding problem. Still looking for answers.
***********************************************************
Ingrid Kast Fuller (ingrid@cityscope.net)
CityScope Net (http://www.cityscope.net) 1(713)477-6161
109 West Southmore, Pasadena, TX 77502-1001
***********************************************************
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.