>
> I'm trying to get an ISDN customer up and running but am running into some
> difficulty. The customer has an OR-U and is dialing into our PM3 but not
> connecting. ISDN debug shows the following....
>
> dial triadntr
> Starting dial to location triadntr using S1
> NC-CAP OR-U> S1: Sending Call Request - 35851882
> S1: Received Call Sent
> S1: Received Disconnect Cap Not Implemented
> S1: Received Call Clear
> S1: Redialing at alternate 56Kbps rate
> S1: Sending Call Request - 35851882
> S2: Register Failed - Telco Not Responding
> S2: Received Disconnect Ack Temporary Failure
> S1: Received Call Sent
> S1: Received Disconnect Cap Not Implemented
> S1: Received Call Clear
>
> The customer told me that I would need to prefix our dialup number with a
> "3" because his ISDN line was centex. I tried dialing with and without
> the 3 prefix but I get the same results. S2 is still showing NO SERVICE
> with the error 'spid not registered'. Any ideas on the error from S1 ??
>
It isn't talking to the telco. The telco settings are not correct.
Either the switch-type, SPID, or directory number is off. Make sure that
everything matches just as the phone company gave you. After you've set
the switch type you also need to reboot. Do a "show s1" and "show s2"
make sure the SPIDs are correct, etc.
Josh Richards - <jrichard@livingston.com>
Beta Engineer
Lucent Technologies (Remote Access Business Unit)
(previously Livingston Enterprises, Inc.)
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.