John,
I don't know if this applies to your problem but I experienced a PM2 BRI
problem with a Hunt group not rotating through the numbers. The solution
was to setup the DNs and SPIDs in the *same* order on the BRI as the telco
had them in the Hunt group.
What I mean is:
BRI 1 DN1 SPID1
DN2 SPID2
BRI 2 DN1 SPID1
DN2 SPID2
When the number in the telco HUNT group were set this way, the Hunt group
would stop rotating after the second number.
BRI1 DN1
BRI1 DN2
BRI2 DN2 < --------------------
BRI2 DN1
Swapping the DNs and SPIDs on BRI2 made the Hunt group rotate past the
second number. Ths PM2 looked like this:
BRI 1 DN1 SPID1
DN2 SPID2
BRI 2 DN2 SPID2 < ---------
DN1 SPID1 < ---------
Hope this helps.
Butch
Butch Kemper | Free sound advice available
Kemper & Associates Consulting Group | "95% sound and 5% advice"
409-361-2324 | Refunds cheerfully provided
-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 5.5.3 for non-commercial use <http://www.pgp.com>
iQA/AwUBNLffKChIHyLj1QScEQJQLQCcCXKfwMptXDwsvqoyd80vgQ9rE6YAoIk6
jzuEhkHVyM7R7NiQhbY0KsG4
=1kVd
-----END PGP SIGNATURE-----
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.