Re: (PM) set line1 t1 HELP (fwd)

Wayne Bouchard (web@typo.org)
Sat, 29 Nov 1997 23:39:01 -0700 (MST)

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Alex Rubenstein: "Re: (PM) OR-u sync port on-demand dial-out-only woes. (fwd)"
Previous message: MegaZone: "(PM) 56k DDS un-numbered w/27 bits (fwd)"
In reply to: MegaZone: "(PM) set line1 t1 HELP (fwd)"

> Once upon a time Steve Goodridge shaped the electrons to say...
> >Having trouble recalling the config details for using one of the PM3 ports
> >for a Point to Point T1.
>
> I can't recall the commands off-hand, but they should be in the PM-3 Install
> Guide. And probably in the latest config and/or command line guides.
>
> There is a command to set it into leased-line mode, then you configure it
> like any other Livingston WAN port.

'set line0 t1/'
'save all'
'reboot'

Once it comes up, you should see port W0. Configure this like any
other synchronous port.

----------------------------------------------------------------------
Wayne Bouchard GlobalCenter
web@primenet.com
Primenet Network Operations Internet Solutions for
(602) 416-6422 800-373-2499 x6422 Growing Businesses
FAX: (602) 416-9422
http://www.primenet.com http://www.globalcenter.net
----------------------------------------------------------------------
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.

Next message: Alex Rubenstein: "Re: (PM) OR-u sync port on-demand dial-out-only woes. (fwd)"
Previous message: MegaZone: "(PM) 56k DDS un-numbered w/27 bits (fwd)"
In reply to: MegaZone: "(PM) set line1 t1 HELP (fwd)"