MZ???? Whatcha know? Rack all those brains at your office! :)
Greg Hughes
CyberPort Station
Farmington, NM
-----Original Message-----
From: John Driscoll <jfd@prime-x.net>
To: Rick Rountree <rick@dundee.net>; portmaster-users@livingston.com
<portmaster-users@livingston.com>
Date: Wednesday, August 27, 1997 10:20 PM
Subject: Re: ESF vs SF on PM3 and CT1
>Hi;
>
>It works with 4 digits, even with NYNEX on the other end!
>
>John
>
>
>On Stardate 27 Aug 97 at 21:52, Commander Rick Rountree said:
>
>> Date: Wed, 27 Aug 1997 21:52:36 -0400
>> To: portmaster-users@livingston.com
>> From: Rick Rountree <rick@dundee.net>
>> Subject: Re: ESF vs SF on PM3 and CT1
>> Reply-to: Rick Rountree <rick@dundee.net>
>
>> At 08:31 PM 8/27/97 -0400, you wrote:
>> >I've got my telco on the phone trying to bring up a PM3 on a CT1. When
I
>> >do a sh line0 I get framing as ESF. The telco wants me to do SF
instead.
>> >How do I make the PM3 do that? Doesn't the PM3 automatically detect
framing?
>> >
>> >Rick Rountree
>> >
>>
>> I feel like an idiot! I was using the manuals that came with my first
PM3
>> and they don't cover half the stuff I needed to look up! At least I
>> couldn't find it... I finally unpacked the new manuals and saw that they
>> were much thicker than the first ones (although the covers were the same
>> color....grrrr!)
>>
>> I went through the all new chapter 11 and got this pretty much licked. I
>> got all the ports to show idle but a "sh line0" status still shows the
line
>> as down. I believe this may be because I ordered # of DNIS digits sent
on
>> wink start as zero based on the provisioning guide on the Livingston web
>> site. The PM3 provisioning guide on the Livingston web site doesn't say
>> anything about DNIS digits needing to be one, in fact, (I just checked),
it
>> says DNIS isn't used and will be supported in a future release. However,
>> the new manual says, page 11-10, "ComOS 3.6-and-later releases require
one
>> DNIS digit."
>>
>> So, Megazone...which is right?
>>
>> Rick Rountree
>>
>>