OR-HS failing to save s0 modem setting.

Warren Vanichuk (pyber@prcn.org)
Wed, 6 Aug 1997 14:13:19 -0700 (PDT)

Greetings. I have a small problem involving an OR-HS, it's not storing the
modem config setting on port S0 properly. I issue a 'set s0 modem usrc-d',
then a 'save s0'.. I've even done a 'save all' just to be paranoid. Every
time the router looses power, it reverts back to the previous modem
configuration, which was another custom modem configuration called 'usrc'.

Any suggestions as to how I can make the changes stick? :)

---- Info :

Command> version
Livingston PortMaster Office Router ComOS 3.5L
System uptime is 1 hours 20 minutes

Command> show s0
----------------------- Current Status - Port S0 ---------------------------
Status: ESTABLISHED
Input: 918904 Parity Errors: 0
Output: 141619 Framing Errors: 1
Pending: 0 Overrun Errors: 0
Modem Status: DCD+ CTS+

Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Hardwired) (Security)
Baud Rates: 115200 115200,115200,115200
Flow Control: RTS/CTS RTS/CTS
Modem Control: on on
Modem Config: Configured usrc-d

Remote Host: cologne.prcn.org cologne.prcn.org
Netmask: 0.0.0.0 0.0.0.0
Interface: ptp0 (PPP,Quiet,Compres (PPP,Quiet,Compress)
Mtu: 1500 1500
Async Map: L:00000000 R:00000000 00000000
Pkt Filters: In:none Out:none
Dial Group: 0

After a power loss, all the settings remain the same, except the Modem
Config, which returns to 'usrc'.

Thanks, Warren
____ ____ ____ _ _ ____________________________________________________
| _ \| _ \ / ___| \ | | Warren Vanichuk, Systems Administrator,
| |_) | |_) | | | \| | Powell River Community Network, http://www.prcn.org,
| __/| _ <| |___| |\ | Powell River, British Columbia, Canada
|_| |_| \_\\____|_| \_| ----------------------------------------------------