I have a probably very simple problem but I can't seem to put my finger on it.
I have an ISDN client using a Ascend P50 dialing in a RNS NetHopper BRI.
Presently, everything works perfectly. I want to move him over a 5 BRI PM2
card. When the P50 dials in the PM2, It gets auth and the LAN session goes
up. From the terminal server screen of the P50, I can ping and traceroute
anywhere on the net but when I do that from another workstation behind the
P50, it doesn't work beside a few adresses including the P50, the PM2 and
the framed address.
The exact same setup works perfectly well with the NetHopper. On the P50,
I created anoter connection profile identical to the first one exept for
the dial number and the IP option. The NetHopper profile is configured for
system based routing and the PM2 profile is for interface based routing.
The "rem addr" is alson changed between two tries. Since everything works
from the P50 but not on its network, I guess it has something to do with
routing and/or the the "LAN adrs", "WAN Alias" or the "IF adrs" settings.
Can someone who has a working setup like that share some info with me. The
P50 is running 4.6c and the PM2 3.5.1b17. Here's my radius attributes
(from Radius NT on Access) for this user.
RadAttributeID Data Value
7 PPP 1
8 207.134.184.242
9 255.255.255.224
10 Broadcast-Listen 3
22 207.216.157.0 207.134.184.242 1
12 1500 1500
13 Van-Jacobsen-TCP-IP 1
Thank in advance.
JF.
-----------------------------------------------------------
INTERNET - BBSI Inc. + Fournisseur de Service Internet
Jean-Francois Laplante + et
jeff@bbsi.net + Babillard Electronique
http://www.bbsi.net ----------------------------------
418-968-6381 modems + Internet Service Provider
418-968-4433 voix/voice + and
418-968-5634 fax + Electronic Bulletin Board
141 Regnault Sept-Iles Quebec G4R 4M4
-----------------------------------------------------------