we have 4 POP. Each POP have one PM2-ER-10 Rel 3.3.2 connected over =
Frame Relay.
Each PM have the same configuration. They are working well since.. since =
the 3.3.2 was avalaible.
For two weeks ago, 1 unit stop working. Rebooting the unit give us two =
minutes to see if the config is ok and .. blocked again. It's now =
"stable" again, but we have had to set RIP OFF.
New problem, we can't open a Telnet session to this unit over Frame =
Relay.
Any suggestion ?
The rel 3.5 doesn't allow Frame Relay to start.
We don't have tryed with the rel 3.3.3
Thank You for Your Help
gabriel
Tercom SA
Switzerland
+41 26 460 33 00