Wondering if you can help with a little configuration issue?
This is the system config :
I have a PPro180 server running NT4.0 and 64MB RAM connected to a
Livingston PM2e-R. The WAN port is connected to a 56K Frame relay line.
NTserver on 204.50.3.1
PM2 on 204.50.3.2
PM2 WAN port (W1) on 207.107.201.70
Upstream gateway 207.107.201.69
I can get out to the internet just fine from either a dialup or the console
but nobdy can get in from the outside world. The ultimate firewall eh?
For example, if I dial up through another service provider and try to reach
www.redshift.bc.ca, no go. I can ping as far as my WAN port
(207.107.201.70) but no further, not even the ether port of the PM2
(204.50.3.2). From this I figure its a routing problem in the PM2. Heres
the route table from the PM2:
enola> show route
Destination Mask Gateway Source Flag Met Interface
----------------- ---- -------------------- ------- ---- --- ---------
0.0.0.0 0 207.107.201.69 local NSC 1 frmW1
207.107.201.68 30 207.107.201.70 local NL 1 frmW1
204.50.3.0 24 204.50.3.2 local NL 1 ether0
enola> show table netmask
Active Netmasks:
Network Netmask Type
---------------- ---------------- -------
204.50.3.0 255.255.255.0 Static
207.107.201.69 255.255.255.255 Static
207.107.201.70 255.255.255.255 Static
207.107.201.0 255.255.255.252 Dynamic
Stored Netmasks:
Network Netmask
---------------- ----------------
204.50.3.0 255.255.255.0
207.107.201.69 255.255.255.255
207.107.201.70 255.255.255.255
No filters set
Any Ideas would be greatly appreciated!
Thanx
Andrew Barton
RedShift Information Technology