The W1 port is connected to a Phillips TA Multi (128k ISDN). When the
link dies, I get the following message in the syslog:
Apr 20 12:58:07 pm1 portmaster: port W1 terminated - User Error - PPP NCP
Active to Request
However, the Phillips TA does not drop the link.
This is the config on my W1 port:
----------------------- Current Status - Port W1 -------------------
Status: ESTABLISHED
Input: 9969468 Abort Errors: 3
Output: 500654864 CRC Errors: 0
Pending: 0 Overrun Errors: 0
TX Errors: 1 Frame Errors: 0
Modem Status: DCD+ CTS+
Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Netwrk Netwrk (Dial Out)
Line Speed: Ext 64K Ext Clock
Modem Control: off off
Remote Host: serial3-0-15.cor1.mel.c
Netmask: 255.255.255.0 0.0.0.0
Interface: ptpW1 (PPP,Quiet) (PPP,Routing)
Mtu: 1500 1500
Dial Group: 1
pm1> ver
Livingston PortMaster PM-2e ComOS 3.5
System uptime is 50 minutes
pm1>
Now, the output is of a concern as well, as this is an 64k ISDN line and I
am positive it is very hard to put 500mb down a 64k line in 50 mins.
This is a problem as I am getting W1 uptimes of only a couple of miniutes.
Ideas?
Regards,
Mikel
-- ----------------------------------------------------------- Mikel Lindsaar | "The dream is the foundation, mikel@cynet.net.au | of our society!" ----------------------------------------------------------- Cynet! The Business ISP! http://www.cynet.net.au/ -----------------------------------------------------------