installing additional MOD-101-U in a PM2Ei (fwd)
MegaZone (megazone@livingston.com)
Wed, 13 Nov 1996 21:29:11 -0800 (PST)
Once upon a time Bob Collie shaped the electrons to say...
>the box seems to reject it. This card should show up as S10-S19, and I've
>verified that J6 is set properly (1-2 jumped). When I turn the box on, all
>of the lights in the back flash accordingly, however, when I finally telnet
>into the box a sh isdn only shows the first BRI card and sh sess only shows
>C0, S0-S15. Additionally, the box is VERY slow and users have problems
>connecting to the first 5 BRI's.
That sounds so much like a jumper error... Lower card is 1 to center.
Upper card is center to 2. Right?
Put a terminal on S0/C0 and watch the boot. How many ports does it find
during boot up?
-MZ
--
Livingston Enterprises - Chair, Department of Interstitial Affairs
Phone: 800-458-9966 510-426-0770 FAX: 510-426-8951 megazone@livingston.com
For support requests: support@livingston.com <http://www.livingston.com/>
Snail mail: 6920 Koll Center Parkway #220, Pleasanton, CA 94566