We did not seem to have the authenticating problem on the our other PMs
running ComOS 3.12 and ComOS 3.13. When our auth server was down users
were still able to log into these PMs.
We've put in a call to Livingston but have not gotten a response back yet.
Regards,
Turnando Fuad
NSNet
On Tue, 21 Nov 1995, Charles Scott wrote:
>
> Turnado:
> Yes, we've seen exactly the same behavior.
> PM's have had a bug for some time that if they can't get the accounting
> data to the accounting host and get up to some 100 acounting entries
> backed up, they will stop authenticating! This is a bug that Livingston
> has known about for some time.
> The new problem with 3.14 compounds the problem. What happens now is
> that the PM periodically stops talking to the accounting host. To get it
> going again, you can just use "set accounting {address}" again with the
> same address. That apparently resets something in the PM and the backed
> up accounting data floods out.
> Since Livingston hasn't fixed the old bug, your PM will stop
> authenticating some time after it stops sending out the accounting data.
> This is a bad situation since we really NEED the accounting data and the
> connect/disconnect log entries aren't reliable enough to use for that.
> We can't have the accounting enabled on the PM because it is then
> guarenteed to stop authenting at some point.
> We have also seen a similar problem arise with authentication between
> the PM and our authentication host. This has only happened once, but was
> easily identifiable as a failure at the PM. I suspect that there is some
> kind of low level problem with the PM's IP I/O which manifests this way.
> Livingston MUST be working hard on this problem because they apparently
> don't have time to respond to my E-Mail on this and other problems anymore.
>
> Chuck Scott, Pres.
> Freeway, Inc.
> cscott@freeway.net
>
>
>
> On Sun, 12 Nov 1995, Turnando Fuad wrote:
>
> > Our Radius acct server was down for a few hours today and we noticed that
> > one of our PMs with ComOS 3.14 stopped accepting dial-in connections
> > around that time. It still wasn't accepting connections when the server
> > came up. It worked again after a reboot. The rest of our PMs are running
> > ComOS 3.12 and continued to accept connections just fine. Our
> > authentication and accounting servers are on different hosts. Has anyone
> > else seen this behavior?
> >
> > Thanks in advance,
> >
> > Turnando Fuad
> > NSNet
> >
> >
> >
> >
> >
> >
>