i think the comnmands were like this...
set s10 login network dialin
set s10 speed 1 115200
set s10 speed 2 115200
set s10 speed 3 115200
set s10 termtype vt100
set s10 service_login rlogin
set s10 host x.x.x.1
set s10 idletime 45
save s10
reset s10
there are a few other commands i use... if you use radius... then my
input is pry not very helpful..... thought id try though... i have the
security bit off if i remember....
another thing i did to route to a bbs was to create an account like this
add user bbs
set user bbs service rlogin
set user bbs host x.x.x.2
save pass
to route people without shell logins to my bbs.... it is not elegant yet
will reprompt them for a bbs login... might be a temp type fix for you...
i am not using radius at this point... soon... time to wakup that web
guy from merit at three in the morning and say... hey... lets do an
install....
On Sat, 25 Nov 1995, Christian Nielsen wrote:
> On Sat, 25 Nov 1995, Tim Flavin wrote:
>
> > Bring the hat back out, I have the drums :)
>
> good. if we all do this at the same time around the pm net, we could
> probally fix all the problems...
>
> > Try telnet from the 2eR and then see where you are logged in from and add
> > that IP to the hosts.equiv file.
>
> Done that..
>
> > Is this 2eR to a remote pop or is it your main router? For some reason
> > on our remote 2eR I had to set the gateway to 0.0.0.0 with a metric of 1
> > and everything seemed to clear up when I did that.
>
> tried, no go.....
>
> Christian Nielsen cnielsen@vii.com,CN46,KB7HAP
>
> Vyzynz International Inc.
> Phone 801-568-0999 Fax 801-568-0953 PS :)
>