Yep... Got up on Thursday and been going since then...
>gives up. So, how do I configure a different local IP address for the
>PM to use for this connection? Keep in mind that it is the PM that is
Can't be done at this time. You can't set a local address in a location.
Fixes:
1. Use SLIP, it doesn't care about the addresses, just pumps the packets
down the line.
2. Have them change the address you get to be your ether0.
-MZ
-- Livingston Enterprises Technical Support Phone: 800-458-9966 FAX: 510-426-8951 support@livingston.com <http://www.livingston.com/> 6920 Koll Center Parkway #220, Pleasanton, CA 94566